 |
2395 Route 132, Greater Lakeburn, NB Canada E1H 1Z8
Telephone:(506) 858- 8108 FAX (506) 855-8774 Email:
crounmac@nbnet.nb.ca
 
In Line proof Tester model CM-ILTT-2-8.
Our in-line Proof Tester tests 2x3 to 2x8
to a maximum tension of 20000 lbs at a rate of 12 pieces per minute. It includes an
integral loader, broken piece separator, hydraulic unit and control panel.
| Key Benefits |
Operation |
-
20,000 lb. tension capacity
-
2x3 thru 2x8 dimension specimen
-
Closed loop servo tension control
-
Adjustible gripper force
-
Movable end gripper up to 50'
-
Broken piece gate
-
Intermediate support cylinders
-
PLC control
-
Digital force display
-
Programmable force targets
-
High-friction gripper facing
-
12 ppm cycle rate
|
- Singular gets load signal
- Specimen drops between gripper faces and
rests on support cylinders
- Sensors signal "piece in place"
- Grippers close, tension begins, support
cylinders retract pull to set point.
- If OK, release tention and open grippers
- If broken, gate activates to deflect pieces
to reclaim conveyor
- Repeat sequence
|
[ Main Page ]
[Request Information]
[ In-Line Tension Tester ]
[ Laboratory Tension Tester ]
[ Bending Proof Tester ]
[ Drying Ovens ]
Crown Machine and Welding Ltd.
2395 Route 132, Greater Lakeburn, NB Canada E1H 1Z8
Telephone:(506) 858- 8108 FAX (506) 855-8774
Email: crounmac@nbnet.nb.ca |